Do Hockey Players Still Heat Their Sticks? Blade Curves - Big Shot Hockey (2024)

The game of hockey has evolved over theyears with changes to the sport’s rules and equipment. One of themost dramatic of these changes has been the continuing evolution ofthe hockey stick. With the introduction of the one-piece compositestick, players have found they rarely have to tinker with the stick’sblade anymore to adjust its curve.

Hockey players are known to heattheir sticks to bend the blade. This enables them to customize theblade’s curve to their own personal liking. While this was a commonpractice before composite sticks were introduced, it’s rare that aprofessional player needs to heat their stick anymore since theirsticks are all custom made by the manufacturer.

Wooden sticks

Oncethe perfect amount of curve was on the blade it would then be placedin cold water or a bucket of ice to cool down while retaining its newcurve.

Reason for more curvature

Hockey players decided to start curving the blades of their sticks decades ago as they found it was easier to raise the puck off the ice with a more pronounced curve. They could target the upper portion of the net from a close distance with a bigger curve as the speed and trajectory of their shots would be changed.

It’s also believed the velocity of ashot could be increased with a greater curve and the shots were moreunpredictable for goaltenders.

Former NHL players such as Bobby Hull and Stan Mikita were well known for altering their sticks.

However,some players got carried away when tinkering with their sticks andthe curvature of their blades was taken to the extreme. These becameknown as “banana” blades.

TheNHL now hasa rule regarding the curvature of a stick’s blade which statesthe curve can’t exceed3/4 of an inch at anypoint on the blade. The league has a measuring device at all gamesand a player who uses a stick with anillegal curve is assessed a two-minute minor penalty.

Composite sticks

Composite hockey sticks can also be altered by heating the blade and some pros still do this to find the ideal custom curve and then send the specifications to the manufacturer.

To do this you should heat the blade evenly from heel to toe for approximately a minute. This can be done with a blowtorch or with the heat from an oven element. When the blade is hot it can be curved by hand or with your foot.

If curving the blade by hand it’s a good idea to wear an oven mitt when doing so, to protect your hands from the heat.

Be aware that this process may have to be repeated several times to get the curve you’re looking for and make sure the curve isn’t illegal – especially if you’re planning to play in any competitive or organised leagues.

Whenyou have the ideal curve place the heated blade in ice or cold waterfor several minutes to let it harden. The stick should then be readyto use once it has cooled and hardened.

It’s also important to note that the manufacturer of the stick may not honor the warranty if the stick has been altered in any way. In addition, some sticks may come with heat-sensitive blades and could be damaged permanently when heated.

Heating the stick’s shaft

While heating the blade of a hockey stick has been a common practice since the 1960’s you’ll find that some players may also heat the shaft of their sticks for various reasons.

Some players will heat the tape on the knob of their sticks so it will adhere quicker and stronger to the top of the shaft. They may also heat a plastic knob or plug-in stick extension to melt the glue for a stronger bond.

Hockey players don’t heat theirsticks nearly as much as they used to since pro players have theirsticks custom designed. Amateurand recreational players are also more unlikely to try and altercomposite sticks since they could end up ruining an expensive pieceof equipment.

But if you’re still one of the few that use a wooden hockey stick or blade you may be more inclined to heat it as a way to alter its curve.